Sensplorer Modbus RTU Monitoring Software Licence

Sensplorer RS-232 / RS-485 Modbus RTU Software License must be installed for Sensplorer to monitor the devices and sensors connected to the Serial Modules attached to the Sensplorer X / M / S Main Modules themselves or to the CAN line.

• Each of the parameters selected among the addresses on the Modbus address table published by the manufacturer of the devices to be monitored is added to the system as a sensor. Reading, writing and reading / writing functions via Modbus addresses are all possible if the device allows it.
• Warning / Alarm levels can be defined for sensors produced from modbus addresses that provide analog data.
• For sensors produced from modbus addresses that generate logical (0/1, Yes / No etc.) data, an Alarm status definition is entered. Monitoring is done with the definitions created over them.
• In order to add the device to Sensplorer X / M / S Main Modules, a definition file must be created on the Sensplorer side. Modbus addresses to be used in this file are defined as sensors.
• The created sensors can also be assigned to certain groups like other sensors, and rules can be defined over them. It functions similar in all respects to any Sensplorer sensor.